Method:
STEP 1 Wrap the bezel wire around the leaf bead from the top all the way around the sides of the bead and back up to the top again make sure you have a small overlay and then trim to size.
STEP 2 Holding the wire around the bead thread the headpin through the bezel wire and the base of the bead and the when you get to the top of the bead make sure you get the head pin through through both ends of the bezel wire, you will want a tight fit. I found the best way to get that is by using a heavier guage scape of wire that I inserted in the top of the bead holding the bezel wire ends in place, as I pushed my headpin up through the bead from the bottom I pulled the scape of wire out at the least minute.
If you find this method too fidly follow the instructions on this U-Tube video
https://www.youtube.com/watch?v=BUyVT_O8lCo STEP 3 thread the 2mm bead onto the headpin and make a tight wire wrapped loop. thread onto the sheppard.
Trim and Finished
See wire wrapping loop instuctions
To purchase individual products used follow the links provided